Main rangeTeSys product nameTeSys T device short nameLTMR product or component typeMotor controller device applicationEquipment monitoring and control measurement current0.4...8 A [Us] rated supply voltage100...240 V AC 50/60 Hz current consumption8...62.8 mA supply voltage limits93.5...264 V AC communication port protocolProfibus DP bus typeProfibus DP polarised 2-wire RS485 interface, addressing 1...125, transmission rate 9.6 kbit/s...12 Mbit/s, SUB-D 9 with 2 shielded twisted pairs, type AProfibus DP polarised 2-wire RS485 interface, addressing 1...125, transmission rate 9.6 kbit/s...12 Mbit/s, terminal block with 2 shielded twisted pairs, type A Complementary [Ui] rated insulation voltage690 V conforming to CSA C22.2 No 14690 V conforming to EN/IEC 60947-1690 V conforming to UL 508 [Uimp] rated impulse withstand voltage4 kV for supply, inputs and outputs conforming to EN/IEC 60947-4-16 kV for current or voltage measurement circuit conforming to EN/IEC 60947-4-10.8 kV for communication circuit conforming to EN/IEC 60947-4-1 short-circuit withstand100 kA conforming to EN/IEC 60947-4-1 associated fuse rating0.5 A gG for control circuit4 A gG for output protection typeEarth-leakage protectionPhase failureReverse polarity protectionThermal overload protectionThermal protectionOverloadPhase unbalanceLocked rotorOverload (long time)Load fluctuationPower factor variation network and machine diagnosis typePhase fault and earth fault trip countersRemaining operating time before overload trippingRunning hours counter/operating timeStarting current and timeWaiting time after overload trippingFault recordingEvent recordingTrip context informationTrip history informationMotor control command recording logic input number6 input current3.1 mA at 100 V7.5 mA at 240 V current state 0 guaranteedLogic input : 0...40 V and <= 15 mA for 25 ms current state 1 guaranteedLogic input : 79...264 V and >= 2 mA for 25 ms maximum output switching frequency2 Hz load current5 A at 250 V AC for logic output5 A at 30 V DC for logic output permissible power480 VA (AC-15), Ie = 2 A, 500000 cycles (output)30 W (DC-13), Ie = 1.25 A, 500000 cycles (output) operating rate1800 cyc/h contacts type and composition1 NO + 1 NC fault signal3 NO metering typeEarth-fault currentPhase current I1, I2, I3 RMSTemperatureAverage current IavgImbalance current measurement accuracy3 % power factor (cos φ > 0.6)+/- 30 min/year internal clock0,02 temperature5...15 % earth fault current internal measurement (for current > 0.1 A)1 % current1 % voltage (100...830 V)5 % active and reactive power5 % earth fault current external measurement (< 5 % or 0.01 A) overvoltage categoryIII connection pitch5.08 mm connections - terminalsConnector, 1 flexible cable with cable end 0.25...2.5 mm² /AWG 24...AWG 14 for control circuitConnector, 1 flexible cable without cable end 0.2...2.5 mm² /AWG 24...AWG 14 for control circuitConnector, 1 flexible cable without cable end 0.25...2.5 mm² /AWG 24...AWG 14 for control circuitConnector, 1 solid cable without cable end 0.2...2.5 mm² /AWG 24...AWG 14 for control circuitConnector, 2 flexible cable with cable end 0.2...1 mm² /AWG 24...AWG 14 for control circuitConnector, 2 flexible cable without cable end 0.2...1.5 mm² /AWG 24...AWG 14 for control circuitConnector, 2 flexible cable without cable end 0.5...1.5 mm² /AWG 24...AWG 14 for control circuitConnector, 2 solid cable without cable end 0.2...1 mm² /AWG 24...AWG 14 for control circuit tightening torque0.5...0.6 N.m, 3 mm flat screwdriver for control circuit pollution degree3 electromagnetic compatibility● electrostatic discharge 3 (8 kV air, 6 kV contact), conforming to EN/IEC 61000-4-2● fast transients immunity test other circuits level 3 (2 kV), conforming to EN/IEC 61000-4-4● fast transients immunity test on supply and relay outputs level 4 (4 kV), conforming to EN/IEC 61000-4-4● conducted RF disturbances (10 V), conforming to EN/IEC 61000-4-6● surges serial mode (1 kV) control circuit, conforming to EN/IEC 61000-4-5● surges common mode (2 kV) communication, conforming to EN/IEC 61000-4-5● surges common mode (2 kV) control circuit, conforming to EN/IEC 61000-4-5● radiated RF fields 3 (10 V/m), conforming to EN/IEC 61000-4-3● voltage dips and interruptions immunity test (70 %, 500 ms), conforming to EN/IEC 61000-4-11● surges serial mode (0.5 kV) temperature sensor, conforming to EN/IEC 61000-4-5● surges common mode (1 kV) temperature sensor, conforming to EN/IEC 61000-4-5● surges serial mode (2 kV) relay outputs and supply, conforming to EN/IEC 61000-4-5● surges common mode (4 kV) relay outputs and supply, conforming to EN/IEC 61000-4-5 width91 mm height61 mm depth122.5 mm product weight0.53 kg web servicesWeb server compatibility codeLTMR Environment standardsEN 60947-4-1IACS E10IEC 60947-4-1UL 508CSA C22.2 No 14 product certificationsABSATEXBVCCCCSAC-TickDNVGLKERILROS (Lloyds register of shipping)NOMRINARMRoSULEAC protective treatment12 x 24 hour cycles conforming to EN/IEC 60068-2-3048 h conforming to EN/IEC 60070-2-11TH conforming to EN/IEC 60068 fire resistance650 °C conforming to EN/IEC 60695-2-12960 °C conforming to UL 94 ambient air temperature for operation-20...60 °C ambient air temperature for storage-40...80 °C operating altitude<= 2000 m without derating mechanical robustness● shocks half sine wave acceleration (15 Gn for 11 ms) conforming to EN/IEC 60068-2-27● vibrations mounted on symmetrical rail (1 Gn, 5...300 Hz) conforming to EN/IEC 60068-2-6● vibrations plate mounted (4 Gn, 5...300 Hz) conforming to EN/IEC 60068-2-6 IP degree of protectionIP20 Offer Sustainability Sustainable offer statusGreen Premium product RoHS (date code: YYWW) REACh Product environmental profile Product end of life instructions Contractual warranty Warranty period18 months
Documents and DownloadsLanguage
CatalogueSizeAdd to My DocumentsUser guideSizeAdd to My DocumentsCADSizeAdd to My DocumentsMotor controller LTMR TeSys T - 100..240 V AC 8 A for Profibus DP (Version 1.0)CAD files for LTMR08PFM: Motor management system TeSys T - ProfiBus motor management (Version 1.0)Motor controller LTMR TeSys T - 100..240 V AC 8 A for Profibus DP (Version 1.0)BrochureSizeAdd to My DocumentsCertificateSizeAdd to My DocumentsInstruction sheetSizeAdd to My DocumentsEnd of Life InformationSizeAdd to My Documents
No results foundUnfortunately, related FAQs are unavailable due to temporary technical issues. Please try again later.